BelleInterior[dot]com - Architecture, Interior And Construction

---

How: put a thermostat in the radiator Posted: 26 Nov 2014 03:40 AM PST The winter is just around the corner, and with it climatic bad time. This means that soon we will begin to cover, clothes for protection and, of course, to turn the heatingto dive. If you pass or fall in the coming winter cold, but spend no assets when it comes to the gas bill to the key, you can of your heater with integrated thermostat on the other hand change. This practical device can buy it in any DIY store and help you rules the temperature of the radiator, and thus, to reduce our energy consumption. If you have your new key, you can contact in a fast and easy way, without an expert in DIY. The first step is the heating and empty the circuit. Later, you must solve the screws, which revoked the valve on the cooler and the piece with two English key.To prevent possible rupture is good a trick , keeping up with the line are the first wrench while we resolve with the other mother. You have this step not haste when it comes, and take the time you need, to be sure, that to make you good. If you have completely removed the old piece, you must set the new one make sure that the diameter of the thread is compatible. It is the universal sealant in the limbs of our new key with thermostat and screwed valve by hand. Finally, you must drag for nuts to the previous step, i.e. holding the tube with a key and rotate the mother with the other. Like you, it is much easier than at the beginning have a job you it had imagined see, you need only patience, a little practice and appropriate materials. The post How: put a thermostat in the radiator appeared first on Belleinterior.

Repair cleft in the ground Posted: 25 Nov 2014 03:40 PM PST If you have discovered a small crack in the ground from home and want to fix, rather than each Member of your family will discover on, it will be better, follow the instructions , we offer below the letter. A trade that you need not help of every Mason, only a spatula, a mass for this type of work, water and a small dose of patience and good humor. The first step is to remove the dust with the help of a Paletina and thoroughly dace. Protect you to avoid the area with body band to unnecessary patch, and then prepares the mass used to fill this gap. This step is as easy, as you follow you instructions, specified by the manufacturer, i.e., mix the dough with water and stir now both materials get a pasta homogeneous. He is considered the dough with a palette knife on the affected area, make sure that you crack that fully cover. If the product is dried, you need to on the surface of the affected area an elastic sealing PuTTY along with request-based rubber and with fiber glass reinforced. Ask for this product in your DIY store and specifies the task in question, because you surely will find the article we are looking for you. Before this PuTTY is dry, we need to carefully go to avoid the appearance of pockets of air scraper, make sure that the surface is dry. Then remove the tape, and wait that the material in the meantime is completely dry, protect the surface , I recommend to avoid that they are dirty or damaged. The post Repair cleft in the ground appeared first on Belleinterior.

You are subscribed to email updates from Belleinterior To stop receiving these emails, you may unsubscribe now.	Email delivery powered by Google
Google Inc., 1600 Amphitheatre Parkway, Mountain View, CA 94043, United States